How to build a false wall with your own hands – installation tips. Nobody will notice the difference with this wall.
If a question “how to build a false wall” is in your agenda now, you must first decide what you want to get as a final result. For example, if you are planning to combine the kitchen with a small living room separated by a sliding door, the ideal solution for your situation is a false wall of plasterboard. There are many situations when a fake wall allow you to create unique designs that can transform your room in a very special way.
Materials and tools
- a drill,
- a screwdriver,
- a hammer,
- a nozzle,
- metal nails,
- wide and narrow spatulas of different sizes
The steps to start:
- the acquisition of the necessary amount of plasterboard,
- calculating it,
- finding out the data of the total area of the walls of the room.
Attention! Drywall is fragile material, so the quality of the tool, use the appropriate nozzle, do not damage the structure of the sheets of plasterboard.
Preparing the surface
- prepare all the communications for the working period – after the construction of your false wall it will be very problematic to do;
- remove the entire finish of the old wall,
- seal cracks;
- process the segments with mold (if there are any) with special solutions.
The construction of the lathing
There are two variations of the wall skeleton which can be used in the construction of false walls.
- Wooden lather
Among its advantages are cheapness and ease of installation.
But the main disadvantages of this design are its unreliability and fragility. Unfortunately, to extend its service life it is necessary to use very the expensive antiseptic which can protect the timber from mold and rot, but in this situation, so, as you can see, the cheapness advantage is immediately abolished.
- Metal lathing
This design is characterized by reliability and durability. Its main advantage which makes this design very attractive for every person who is interested in practicality is that it can always be reused. It sounds surprisingly, but even bent the metal frame can be reused again and again, because it is always possible to be rectified. Moreover, the cost of the metal profiles is not much higher than that of timber wood ones.
Important! The wooden beam is difficult to find perfectly flat, but the metal rack is quite difficult to bend to the desired shape. So, everything on Earth has its pluses and minuses.
You should start with marking the guide profile. It is mounted on the floor and on the ceiling. Then make a marking of walls on which the brackets will be installed. It should be noted that between the vertical studs a distance equal to half the width of the drywall board should be.
This condition must be followed in order the ends of the material to exactly in the middle of the profile. After this all the necessary holes are done using a drill, and then the dowels are inserted in them. The brackets and the guide profile are bolted on them.
With the fixation of the vertical racks is performed. This process should be given maximum attention, because at the end you must get the perfectly flat plane. To control the process, use a laser level or stretched string. The brackets have a plurality of holes through which you can easily adjust the vertical racks.
After you made sure that the frame is securely fixed, you can start the process of facing it with the help of plasterboard. Sheets of plasterboard should be prepared in advance and spread out in the room. Secure your comfort workflow by removing everything that can be removed around you.
It would be the best way to start from the window or from the doorway. When you work with your first sheet of plasterboard, you should not drill out the holes for screws with a drill, it is better to use screws with a drill at the end of screwing them at intervals of not less than 8 inches.
After the work with plasterboard is finished, make sure that all joints are carefully treated and the overall surface has become even. The primer is used traditionally. The primer is applied by a roller to the entire surface of the wall. This the final stage before the applying of the finishing putty.
After the complete drying of the putty all the seams between sheets must be treated with sandpaper with fine abrasive. After that the surface is coated again with the primer. Now your false wall is ready.
We hope this article helped you to get the necessary information on how to build a fake wall.